Level IIIA plate<\/a>\u00a0for testing. Out of the box\u00a0you immediately notice how light it is. The Level IIIA plate weighs in at just about 3 lbs., 2.7 to be exact which is a drastic difference over most level III plates on the market weighing in at 8 lbs or more. This plate is 10\u00d712 inches and has a single curve shooter\u2019s cut which conforms to the body versus a flat plate, making it much more comfortable to wear allowing it to move with you a bit. I recently held a carbine class and wore this plate along with Legacy\u2019s vest and found the comfort level to be above par and ended the day much less fatigued than heavier armor I have utilized before. A unique feature of the Level III plates from Legacy is that they have Positive Buoyancy, yes \u2013 they float! The inner material is polyethylene which is a type of plastic. The polyethylene is compressed very hard together which gives this plate its buoyant ability.<\/p>\nRange time would be the true test. I affixed the plate to a hanging dummy. To make things a bit more challenging, I did not affix the bottom of the dummy to anything so that my target would swing\/move requiring a bit more effort in target acquisition than a stationary target. The Level IIIA Legacy plate is NIJ compliant is rated for the following ammunition; .357 SIG FMJ, .44, .223, 5.56X45 and 7.62X39. This highest rating for this plate was six rounds of the 7.62X39 so that\u2019s what I chose to run. As you can see in the video all six shots hit the plate. After shooting, it was time to open it up. Looking at the back you could see the BFD (Back Force Deformation) but zero holes or exit points. I had a tight grouping of four shots which caused a higher BFD that enabled the polyethylene to protrude and tear the outer lining but zero penetration of a round. Cutting through the actual plate material proved to be impossible without some type of hand saw, so actually retrieving the rounds was not a possibility at the range. The confidence I had in Legacy armor skyrocketed after this T&E. This armor truly lives up to everything it claims to be. Light, comfortable, dependable and affordable. The MSRP on the level IIIA plate is approximately $249.99.<\/p>\n
I\u2019ve had the pleasure of getting to know the CEO of Legacy Safety and Security, Rob Hausman. I asked Hausman what drove his passion for his company and his response couldn\u2019t have been more genuine.<\/p>\n
\u201cWe only sell light weight body armor as we want everyone performing at their best. We know the importance of not only being protected but being able to perform at high levels. Being former military, I witnessed too many people wearing empty vests because they didn\u2019t want to carry that much weight. Our armor is light to enable individuals to perform at their highest level and not be weighted down. Top peak performance while also being protected at the highest level possible, to be safe. Everything comes down to being safe. That\u2019s what it\u2019s always about, just getting everyone home, every single day\u2026 safe.\u201d Rob Hausman, CEO of Legacy Safety and Security.<\/p>\n<\/div>\n